Skip to content
Shop Our Categories
AWNINGS & COVERS
JACKS & LEVELERS
LIGHTS & LENSES
STEPS & LADDERS
TOWING & SAFETY
VENTS & FANS
What type of repair do we do here?
What do we have for sale?
Help & FAQ
DINOSAUR ELECTRONICS IGNITOR BOARD - FAN50PLUSPINS
The FAN 50 Plus Pins is designed to replace the new Suburban Fan Control boards and the Atwood / HydroFlame Fan Control boards as well as the Dinosaur Fan Control boards which have been available since 1994. This board can also be used to upgrade older furnaces to add the Fan Control feature. The basic purpose of a Fan Control Ignition Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated. The FAN 50 Plus Pins, after shutting the fan motor off, will wait for 1 hour and repeat the whole sequence again before permanent shut down. For 12V DC Furnaces ONLY! The Fan Control feature MUST BE USED for proper operation of this board. Features: Jumper select-able operation. Works in 12V DC furnaces*. Microcontroller. 3.35" x 4.25". Diagnostic LED. *Note: Fan control boards should not be used in DuoTherm 900 series furnaces that have the thermostat in the ground circuit.
Used To Upgrade Older Furnaces To Add The Fan Control Feature
Shuts The Fan Motor OFF If The Board Fails To Sense A Flame After The Third Ignition Try
Battery Drain Is Reduced And The Needless Blowing Of Cold Air Is Eliminated
Compatible With The Fan 50 Plus And UIB Fan Control Boards
Limited 3 Year Warranty.
NORCOLD POWER SUPPLY CIRCUIT BOARD - 632168001
DOMETIC REIGNITER 2931132.019
ATWOOD WATER HEATER, G10-2 94180
SUBURBAN FURNACE MOTOR - 232682
DINOSAUR ELECTRONICS NORCOLD POWER SUPPLY CIRCUIT BOARD -N991
DOMETIC ATWOOD WATER HEATER DOOR 6GAL 91386
NORCOLD REFRIGERATOR, DE-0041R
DINOSAUR ELECTRONICS IGNITOR BOARD-UIBLPOST
Share your knowledge of this product.
Be the first to write a review »
Browse for more products in the same category as this item: